A fatal error has occured while updating your device software Masterbation brooadcast chat room sex
-----[An error has occurred and this utility has aborted]-------------------- This error is generated by TI's USCIF driver or utilities. The cause may be one or more of: invalid XDS100 serial number, blank XDS100 EEPROM, missing FTDI drivers, faulty USB cable.
Use the xds100serial command-line utility in the 'common/uscif' folder to verify the XDS100 can be located.
the cable pod of an XDS560v2), that is called Cable Break Near.
Technically a cable break is detected by a pin that is grounded when the cable is plugged in.
The previous page with legacy information is still available at the Debugging JTAG Connectivity Problems legacy page.
When having trouble with a connection, follow the steps below to identify what could be the most probable root cause for the problem.
Check section 3 of the CCSv6_Getting_Started_Guide for install instructions.
Check if the target configuration file (.ccxml) accurately describes your JTAG debug probe (Connection) and target (Device or Board) and use the Test Connection button to determine whether your JTAG connection is working at the lowest level.